Fitting OIl Temp / Press Sensors
#1
Scooby Regular
Thread Starter
Join Date: Oct 2002
Location: At Home
Posts: 1,131
Likes: 0
Received 0 Likes
on
0 Posts
Fitting OIl Temp / Press Sensors
OK firstly I have done a search already and although there seem to be many posts on this, there is nothing conclusive.
So, I need to fit the defi sensors for both oil temp and pressure which I was advised that below the intercooler on cylinder 3 I can do this. I removed the intercooler but could not identify where the sensors plug in.
Does anyone have a diy fitting guide with clear pics of the sensor locations?
Your help is very much appreciated.
NeilW (MY06 STi)
So, I need to fit the defi sensors for both oil temp and pressure which I was advised that below the intercooler on cylinder 3 I can do this. I removed the intercooler but could not identify where the sensors plug in.
Does anyone have a diy fitting guide with clear pics of the sensor locations?
Your help is very much appreciated.
NeilW (MY06 STi)
#2
Twatful
Join Date: Apr 2003
Location: Grew up and don't drive Scoobs anymore!
Posts: 9,050
Likes: 0
Received 0 Likes
on
0 Posts
Unless the block is different, being a 2.5, usually there's a plug above the No3 cylinder that needs a 8mm hex socket to remove and an adaptor plug fitted to install the oil temp sender.
The oil pressure sender simply replaces the OEM one, which is completely useless, under the alternator.
The oil pressure sender simply replaces the OEM one, which is completely useless, under the alternator.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM