Power FC problem?
#1
Scooby Regular
Thread Starter
Join Date: Feb 2002
Location: Athens Greece
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
Power FC problem?
I have a MY97 and i just replace the ECU with a Power FC. I have done the
cam/crank sensor swap (B136- Pin 8 to 10 & 10 to 8) but i can't make the same for the fuel pump connection (B137- Pin 7 to 17 & 17 to 7) because there isn't any cable on pin 7.
Any suggestions?
cam/crank sensor swap (B136- Pin 8 to 10 & 10 to 8) but i can't make the same for the fuel pump connection (B137- Pin 7 to 17 & 17 to 7) because there isn't any cable on pin 7.
Any suggestions?
#4
Former Sponsor
Join Date: Jul 2005
Location: Wellingborough, Northamptonshire
Posts: 2,859
Likes: 0
Received 0 Likes
on
0 Posts
you are correct, there is only one wire to move on the fuel pump, 17 to 7 or 7 to 17 I can't remember the numbers, just move it and it should work. It will need mapping for euro car immediately
Thread
Thread Starter
Forum
Replies
Last Post