sti 6 front bumper lower lip/splitter fitment.
#1
sti 6 front bumper lower lip/splitter fitment.
I've just got my sti6 front lip in the post today but it doesnt come with any kind of fitting bolts or clips. i've phoned a few people that sell the splitter but they just said it should come with a fitting kit.
any ideas?? can i use just self tapping bodywork bolts?
any ideas?? can i use just self tapping bodywork bolts?
#2
Hi
Installed mine on Saturday past... it DIDNT come with a fitting kit. Just used some ordinary bolts and washers. Would use big-ish washers as my first attempt was with small ones and they bit into the plastic. The only area I used Subaru bits for was the wheelarch plugs and I managed to steal a couple of these off someone else.
Cheers
Installed mine on Saturday past... it DIDNT come with a fitting kit. Just used some ordinary bolts and washers. Would use big-ish washers as my first attempt was with small ones and they bit into the plastic. The only area I used Subaru bits for was the wheelarch plugs and I managed to steal a couple of these off someone else.
Cheers
Thread
Thread Starter
Forum
Replies
Last Post
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 07:28 PM
Danny0608
Subaru
6
27 September 2015 02:16 PM
Danny0608
Subaru Parts
0
12 September 2015 02:59 PM