Hi guys
As title am repalcing the cam belt and doing the oil pump oil seal..So pumps off etc: etc:
1-Is the small o-ring that seals the pump pick to the block up easily available ?
2-And what type of sealant have you been using for the pump face to block and hopefully easily obtainable.
Cheers in advance

 

i got the o-ring from api can't remember what sealnt i used think it was orange in colour shouldn't matter to much as long as u dont get it everywere
rob.

 

three bond grey or black is what you are after. grey drys a bit harder but both will seal a ****** clout.

 

Cheers for the replies guys,wheres the best place to get 3 bond,and the seal i ordered today dealer £1.50

 

Just to cap it off oil pump "o ring" part no:806919050 and 3 bond 1215 main dealer £11.50 all in
Cheers guys

 

Why are you replacing the block O ring ? Do you have an oil leak at the front ?

If so, it's more likely to be the front main "oil seal", which is fitted into the front of the oil pump, and you don't need to remove the oil pump to fit it.

Mark.

 

Tnx for reply Mark,had oil leak but not from front seal but have done it anyway,the leak was from the o ring or the pumnp face to block ? but also found the pressure release valve cap loose So done the lot in one and a new belt

 

check the screws on the oil pump back plate are tight.

 

Cheers Paul,all went up at least half a turn each...Looks like it was shaking itself to bits.