Is it 6mm hose that is needed ?


Thanks

Hakon

 

Can't remember now, but measure the bore of the steel tubes on the inlet manifold, but iirc the hose is 6mm inside dia, and MUST be for high pressure fuel injection and not the carb stuff you can buy in Halfords (who also sell the correct pipe).

Graham

 

thought it was 5/16ths, which is a smidge under 8mm?
make sure you get fuel injection hose rather than fuel hose

 

If you are doing a goodridge conversion its -6 which is 8mm or 5/16" as said above.

If you are using normal black fuel injection stuff, just measure wichever part of the rail you are coming off. it will be 6 or 8mm - one of the two.

 

Thanks for the replies.

 

After a lot of searching i managed to find this info

http://www.northursalia.com/modifica.../fuelrail.html