Boost solenoid to airbox pipe
#1
Scooby Regular
Thread Starter
Join Date: Nov 2005
Location: Mow Cop, Stoke On Trent, Staffs
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Boost solenoid to airbox pipe
Whilst refitting my airbox on my 95 wrx i managed to snap the small fitting off the small middle airbox which the boost solenoid pipe (i think thats what it is) pushes on to. What effect would this pipe discharging to atmos have? Can i do this and seal up the hole in the airbox or do i need to replace the airbox ???
#2
Scooby Regular
Are you refering to the approx 20mm re-circ pipe?
Go down your local B&Q and you should be able to find a screw tank fitting that has a threaded insert on one end and a flat pipe outlet, you can use some large washers to fit that to the box giving you a nice new metal inlet.
Go down your local B&Q and you should be able to find a screw tank fitting that has a threaded insert on one end and a flat pipe outlet, you can use some large washers to fit that to the box giving you a nice new metal inlet.
#3
Scooby Regular
iTrader: (2)
Join Date: May 2000
Location: Class record holder at Pembrey Llandow Goodwood MIRA Hethel Blyton Curborough Lydden and Snetterton
Posts: 8,626
Likes: 0
Received 0 Likes
on
0 Posts
You can do as you say, as in block off the hole and VTA the pipe. Its commonly done when eliminating the "middle box" with an induction kit.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM