Cutting and welding titanium
#1
Scooby Regular
Thread Starter
Join Date: Jun 2005
Location: Home
Posts: 14,758
Likes: 0
Received 0 Likes
on
0 Posts
Cutting and welding titanium
The RA has a Fujitsubo Super TI from the resonator back. Beautifully crafted, lightweight piece of kit.
The only thing is I'm not keen on the 4 inch tail pipe. Would much prefer a discreet 2.5 inch jobbie.
Can it be done or does it have to be welded under water and all that kind of nonsense?
J
The only thing is I'm not keen on the 4 inch tail pipe. Would much prefer a discreet 2.5 inch jobbie.
Can it be done or does it have to be welded under water and all that kind of nonsense?
J
#2
Scooby Regular
Join Date: Nov 2001
Location: Leeds - It was 562.4bhp@28psi on Optimax, How much closer to 600 with race fuel and a bigger turbo?
Posts: 15,239
Likes: 0
Received 1 Like
on
1 Post
Can be welded with a tig welder. I can recommend people in leeds that can do it, Id also suspect Ian @ haywards and scott could do it.
David
David
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
17 July 2016 10:43 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
supshon
General Technical
2
03 October 2015 08:06 PM