Indicators
#1
Scooby Regular
Thread Starter
Indicators
Just ordered and received clear indicators and clear side markers from scoobyparts.
Before i go removing the origional orange stuff , how do i get the indicators out the front wings ?
They dont seem to turn and are fairly tight , maybee even bonded ?
At first glanse it looks like i might have to get behind the wing to get them removed.
OOPS - car is an STi 03
I would guess a lot of you guys have replaced these items , any info on removing the origional indicators , oh and those side markers would be fantastic.
Chris.
Before i go removing the origional orange stuff , how do i get the indicators out the front wings ?
They dont seem to turn and are fairly tight , maybee even bonded ?
At first glanse it looks like i might have to get behind the wing to get them removed.
OOPS - car is an STi 03
I would guess a lot of you guys have replaced these items , any info on removing the origional indicators , oh and those side markers would be fantastic.
Chris.
Last edited by sti-chris; 01 February 2006 at 12:58 PM.
#2
on my 93 wrx i pushed the repeater forward and pulled the back edge out they are held in place by a plastic spring clip attached to the repeater it should be visible on you new ones iv seen sum bonded in but that sonly cause the clips broke
hope this helps
hope this helps
#3
Scooby Regular
Thread Starter
Thanks for that , and ur dead right , i just pushed the indicator to the side and it came off easy .Sweet
However the big orange side markers of the front wing dont want to come off quite as easy , any one removed there orange side markers , i can see a small slot but dot really want to put a screw driver between the wing and the reflector ,
Chris
However the big orange side markers of the front wing dont want to come off quite as easy , any one removed there orange side markers , i can see a small slot but dot really want to put a screw driver between the wing and the reflector ,
Chris
#6
Scooby Regular
Join Date: Oct 2005
Location: West London
Posts: 1,914
Likes: 0
Received 0 Likes
on
0 Posts
Chris, I did this yesterday.
Use a credit card and push upwards under the bottom edge of the reflector. They'll just pop out, they have a spring at one end and sit on a lug at the other so just need pushing upwards against the spring to release the bottom lug.
Hope that makes sense, Andy
Use a credit card and push upwards under the bottom edge of the reflector. They'll just pop out, they have a spring at one end and sit on a lug at the other so just need pushing upwards against the spring to release the bottom lug.
Hope that makes sense, Andy
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM