SPA Gauge not working
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jun 2004
Location: West Sussex
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
SPA Gauge not working
Hi, ive just bought a subaru P1, and it has a SPA boost/water temp gauge fitted, i think its a SPA206. it doesnt seam to be working properly the boost shows up -55 and the boost light is on, aslo the temperature doesnt read correctly either, i no the car has recently had a new battery could it of been reset? i have no book either, does any one no how to get it working again?
Cheers
Cheers
#2
Scooby Regular
iTrader: (2)
Do you also get a "FL" code showing up as well?
Hold down the red button for 5 secs to access the menus.
Return to normal mode by holding the button for 2 secs when in the "rEt" menu.
When flicking through the menu, when you get to "tb", hold it down for 2 secs and note down the reading. This is the boost trigger point for the alarm light.
NIck
Hold down the red button for 5 secs to access the menus.
Return to normal mode by holding the button for 2 secs when in the "rEt" menu.
When flicking through the menu, when you get to "tb", hold it down for 2 secs and note down the reading. This is the boost trigger point for the alarm light.
NIck
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM