oil temp/pressure sender units
#1
Scooby Regular
Thread Starter
Join Date: Jul 2002
Location: birmingham
Posts: 1,579
Likes: 0
Received 0 Likes
on
0 Posts
oil temp/pressure sender units
ok got my new guages now and was thinking where is the best place to fit the sender units?
have seen a adaptor plate that fits on the oil filter are these any good?
steve
have seen a adaptor plate that fits on the oil filter are these any good?
steve
#2
Scooby Regular
iTrader: (1)
Join Date: Apr 2005
Location: In the Flatlands of Lincolnshire
Posts: 2,892
Likes: 0
Received 0 Likes
on
0 Posts
I purchased a replacement sump plug and got it drilled and tapped to fit the oil temperature sender. I then got a remote oil pressure gauge T-piece, item 9 page 199 part number 095 in demon tweeks red catalogue. The oil pressure switch is sited below the alternator. Hope this helps Steve
#3
Scooby Regular
Join Date: Jun 2002
Location: Suffolk
Posts: 263
Likes: 0
Received 0 Likes
on
0 Posts
I've been thinking I need the same thing since my engine lost half its oil when the crankshaft oil seal went last week!
I did see the adapter in the red DT catalogue, I wonder if it would fit our filter?
I did see the adapter in the red DT catalogue, I wonder if it would fit our filter?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM