Power fc and the TPS
#1
Power fc and the TPS
Currently have an sti 3 with a power fc mapped by simon. the problem is that during normal driving as you come to a standstill the cel is displayed and on the commander it shows as the TPS voltage being really low, but if you rev the car slightly it goes out and the fault disappears. It happens intermittently. any ideas
banny
banny
#2
Former Sponsor
iTrader: (30)
Join Date: Jan 2005
Location: FB Tuning Workshop - HP27
Posts: 4,219
Likes: 0
Received 0 Likes
on
0 Posts
Have you adjusted the position of your TPS so that the voltage reading is correct?
Should be 0.5v +/- 0.3v when closed and 4.3v +/- 0.3v when fully open.
Sounds like the sensor is not properly adjusted or it's faulty
Should be 0.5v +/- 0.3v when closed and 4.3v +/- 0.3v when fully open.
Sounds like the sensor is not properly adjusted or it's faulty
#4
Scooby Regular
Join Date: Jun 2002
Location: Turkiye, Florida
Posts: 433
Likes: 0
Received 0 Likes
on
0 Posts
I have exactly the same problem as you told. (MY98) I think it is a faulty sensor sometimes it goes down to 0.37v so the CEL appears. I think the best way is to change the sensor with new one but they are not cheap. I doubt sometimes it is also making some hesitation at WOTs.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM