manual boost controller question
#1
manual boost controller question
hi all
im a bit confused over the fitting of the manual boost controller(dawes) i have bought. if it takes the boost source from the turbo compressor and feeds the actuator with no other mods then that is straightforward,but i seem to remember reading a post saying that you need to remove pipes from the boost solenoid and blank them off??? anyone know or can provide simple instuctions?
regards mark
im a bit confused over the fitting of the manual boost controller(dawes) i have bought. if it takes the boost source from the turbo compressor and feeds the actuator with no other mods then that is straightforward,but i seem to remember reading a post saying that you need to remove pipes from the boost solenoid and blank them off??? anyone know or can provide simple instuctions?
regards mark
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM