Crank Shaft oil seal.
24 August 2005, 09:13 AM
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Jan 2005
Location: Devon
Posts: 736
Likes: 0
Received 0 Likes
on
0 Posts
Crank Shaft oil seal.
I replaced the crank shaft oil seal about a month ago.
Since then it has pushed itself forward out of the crank casing and killed itself on the back of the crank pulley.
I am replacing this yet again tonight and was wandering should i have glued etc the new seal to the crank casing (still allowing the crank itself to spin through the center hole)?
Cant detect any sign of end float so not expecting that to be the cause.
Any help would be appreciated.
Since then it has pushed itself forward out of the crank casing and killed itself on the back of the crank pulley.
I am replacing this yet again tonight and was wandering should i have glued etc the new seal to the crank casing (still allowing the crank itself to spin through the center hole)?
Cant detect any sign of end float so not expecting that to be the cause.
Any help would be appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM