Hi Dudes,

Would be great if you could help.

I have a DEFI II controller and six white faced defi gauges. My battery justa bout went dead yesterday and my car struggled to start. When it had finally started my clock had gone to 1.00 so i reset it.

After a while I noticed that the warning level set on my boost gauge was set at 0.9 bar

Not much good as im peaking at around 1.5 bar


Does anyone know how to adjust the peak levels without wrecking everything?!

Thanks very much guys

 

Anyone? Someone?

 

You press the set/warning button, when the red lights on each gauge start flashing.
One gauge will be flashing faster than others.
This is the one to adjust 1st.
You adjust by using the fwd/rwd buttons
Then press set to move on to the next gauge.

Be quick though, you have about 5 seconds to start adjusting before it drops out of set warning mode.

 

press the warn set button, all red leds on each gauge should start to flash, one will be flashing faster than the others, keep pressing the warn/set button until the red led is flashing faster on the gauge you wish to change then by pressing the << / >> ( up & down ) button this will allow you set the gauge at what ever level you req.


Si

 

FPMSL!!!!!!!

Thanks so much guys thats great. Its just so funny that nobody said anything for ages then both of you posted at the same time.

You're like busses (i dont mean you are fat)


Cheers For that........