Hi peeps, due to the fitting of a fmic i have a small prob, the space between the two pipes that the recirc valve goes is at 90 degrees and close together. I could fit the standard one but it looks like i'd have to use a decvent length of pipework and want to keep this to a minimum. I've seen a forge recirc valve which would be ideal but i think it may have to be fitted upside down.

Would fitting it upside down be fine? will it work properly?

Cheers guys, this is to my m8's my99 type r.

 

yup , will work a treat. Just make sure you fit it the right way round

Watch it doesn't rub against any pipes etc and it's secured properly.


Steve

 

Cheers m8, i won't know if its upside down until i get it. I'm presuming the inlet is the bottom pipe and the outlet is the side pipe.