Just recently fitted a Blitz induction kit, eveything seemed well for about a week, but now it feels like its holding back when I floor it. It feels slow and judders slightly as if its trying. Did a search on forums for MAF and looked through that, but my idle is fine so could it be the boost solenoid??? If it is, where is it so I can give it a clean??

 

Found the solenoid. Where are the 2 green wires I need to join together to get it clicking??

 

Found the green conectors (not wire) and cleaned the valve but its still not boosting properly, any thoughts??

 

MAF

A quick diagnostic check will probably confirm it.

Which year scoob do you have?

 

Its an MY99, do Subaru charge for diagnostic checks?

 

You can connect the black connectors together just near the green ones you just mentioned - Then switch it on and the Check engine light flashes - Dont know if you have done this already!!! If the light flashes about 50% on then 50% off there are no fault codes - If it flashes another then you need to read it.

Do a search on the net to find out what they mean.

 

i had a blitz induction kit on my old MY98 wrx and it did exactly as you described! i couldn't work out what was going on so i took it off and put the original back on and it was running perfect again!

induction kits dont do much good on imprezas