bought and fitted my dawes device ,now how to adjust ?
#1
Scooby Regular
Thread Starter
Join Date: Aug 2004
Location: wyboston beds
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
bought and fitted my dawes device ,now how to adjust ?
any ideas people ?, it seems slower than it was at the mo because its turned right down as in just out of the pack.
Cheers Dan
Cheers Dan
#3
Scooby Regular
iTrader: (2)
Join Date: May 2000
Location: Class record holder at Pembrey Llandow Goodwood MIRA Hethel Blyton Curborough Lydden and Snetterton
Posts: 8,626
Likes: 0
Received 0 Likes
on
0 Posts
Turn it up then
You have to slacken the locknut, then turn the body (or the other end) clockwise. Go for 1 full turn at a time, (also check you don't leave the tube twisted) compare how much boost increase from last time, then work your way up until you get to a level you like. You may hit fuel cut if you turn it up too much. Do the runs in 4th gear minimum (preferebly 5th).
Make sure your knocklink is quiet, AFR's OK
You have to slacken the locknut, then turn the body (or the other end) clockwise. Go for 1 full turn at a time, (also check you don't leave the tube twisted) compare how much boost increase from last time, then work your way up until you get to a level you like. You may hit fuel cut if you turn it up too much. Do the runs in 4th gear minimum (preferebly 5th).
Make sure your knocklink is quiet, AFR's OK
Thread
Thread Starter
Forum
Replies
Last Post
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
Reshard1977
General Technical
9
18 September 2015 08:58 PM