impreza headers
#1
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Dec 2004
Location: Hereford
Posts: 479
Likes: 0
Received 0 Likes
on
0 Posts
impreza headers
hello guy's,
i have done a search but couldnt find the information i need, i have a stainless steel header and up pipe that i am told is for a 98 - 02 model.
will this fit a 95 wrx or are there different versions
thank you for your help
regards
daniel
i have done a search but couldnt find the information i need, i have a stainless steel header and up pipe that i am told is for a 98 - 02 model.
will this fit a 95 wrx or are there different versions
thank you for your help
regards
daniel
#2
Scooby Regular
Join Date: Jul 2000
Location: Lancashire
Posts: 2,209
Likes: 0
Received 0 Likes
on
0 Posts
Yes they should fit no problem. Most of the popular headers on the market at the moment (GruppeS, OBX, etc) were primarily designed for MY01-on cars but fit all MYs no problem.
You may need bungs for the Lambda and EGT sensors bosses on the headers depending on where your Lambda probe is currently installed.
Andrew...
You may need bungs for the Lambda and EGT sensors bosses on the headers depending on where your Lambda probe is currently installed.
Andrew...
Last edited by AndrewC; 17 December 2004 at 08:01 AM.
#4
Scooby Regular
Join Date: Jul 2000
Location: Lancashire
Posts: 2,209
Likes: 0
Received 0 Likes
on
0 Posts
That's normal.
If your car has the Lambda sensor in the headers currently then you can just swap it over, if it's in the downpipe then you need a 18x1.5mm bung.
The boss on the uppipe is normally 12.x1.25mm for cars equipped with an EGT sensor.
Andrew...
If your car has the Lambda sensor in the headers currently then you can just swap it over, if it's in the downpipe then you need a 18x1.5mm bung.
The boss on the uppipe is normally 12.x1.25mm for cars equipped with an EGT sensor.
Andrew...
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Jonny mac
ScoobyNet General
10
09 October 2015 12:25 PM