can u change the air filter to a diffrent make after a tek 3
can u change the air filter to a diffrent make after a tek 3
12 September 2004, 08:26 PM
#2
Scooby Regular
Join Date: Mar 2004
Posts: 1,126
Likes: 0
Received 0 Likes
on
0 Posts
Done a few mods to my MY00 after the tek3 ( sti i/c and backbox ) and as far as the knocklink is concerned, no problem. Wouldn't change from panel type filter to induction kit without gettiing the map checked though....maybe others have and it's been o.k?
12 September 2004, 10:01 PM
#5
Ecu Specialist
Confusing info here, if you change a panel filter from one make to another then there should not be an issue, however if you change from a panel to an induction you could upset maf scaling and/or afr depending on whats fitted, going the reverse would be expected to run a car richer and could also upset any specific maf scaling that may have been mapped in to suit the induction.
so which are you considering ?
bob
so which are you considering ?
bob
12 September 2004, 10:58 PM
#6
Scooby Regular
Thread Starter
Join Date: Nov 2003
Location: mansfield
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
iv got a blitz induction but i wana change to an apex induction filter. Iv been through 2 air flow meters with my blitz and i rember a tread about induction kits and apex came out top
Thread
Thread Starter
Forum
Replies
Last Post