Aquamist Distributor fitting?
#1
Aquamist Distributor fitting?
Oh, should of asked...anyone know where the distributor is on an My02? I need the negative connection for a wire on the Aquamist water injection so that the ECU knows the revs...
Anyone with a pic would be handy...cheers guys.
Anyone with a pic would be handy...cheers guys.
#2
Scooby Regular
Join Date: Nov 2001
Location: Leeds - It was 562.4bhp@28psi on Optimax, How much closer to 600 with race fuel and a bigger turbo?
Posts: 15,239
Likes: 0
Received 1 Like
on
1 Post
if you dont know what your doing then I would stop trying to fit this immediatley.
They dont have a distributor...
Some aquamist kits use a feed from an injector..
Speak to Richard Lamb @ Aquamist.. He will help you.
I dont recommend doing this as a DIY job.
David
They dont have a distributor...
Some aquamist kits use a feed from an injector..
Speak to Richard Lamb @ Aquamist.. He will help you.
I dont recommend doing this as a DIY job.
David
#3
Cheers David.
I'm fine with 90% of the fitting...including setting up the map and testing of each part during install. It's just the connections for distributor that I wasn't sure on - now I know why. I'll ask Aquamist for help.
I'm fine with 90% of the fitting...including setting up the map and testing of each part during install. It's just the connections for distributor that I wasn't sure on - now I know why. I'll ask Aquamist for help.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM