Where do I plumb into on a My01 to get the correct reading for boost?

 

anyone.. I need to get this sorted today

I is basically connecting the boost for the SECS unit into the line... At the moment it is between the T piece that is by the actuator and the boost solenoid... it's basically showing no boost at WOT ie it decreases.. I am wondering if it's in the right place

 

Its best to tee it into the small pipe going to the dumpvalve-you get a true reading there on the MY01.

easy

 

I agree fizz........ Fizz hows the car going? did all those mods go to plan

 

Where do I get a T from... it aint that small a pipe?

 

not sure mate, I used the one that came with my defi's

 

Halfrauds, in the windscreen washer bits section.

3/16 T.Piece about £1.50 ish.

Red

 

I'm afraid I have those already and they are too small for the pipe from the dump valve... that has a 6 mm diameter not 4mm !!!!

 

Fizz

Give Graham Goode a ring they should be able to help. 0116 244 0080

Red

 

I think I have managed to find a company who does 6mm t pieces and 6-4mm converters too...

cost... about 50p + vat a piece