fse questions!!
#1
fse questions!!
fitting one of these soon, got a few questions; wheres best to locate the new valve? is the standard item just in front of the actuator? can you use the gauge as a permenant thing or remove when setup? thanx in advance.mark
#2
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
Locate anywhere really.. I have ended up with mine bolted to the bulk head
Yes gauge is left fitted all the time.. standard item is indeed in front of actuator..
Other useful diagram (Thanks to AndrewC)
JGM
Yes gauge is left fitted all the time.. standard item is indeed in front of actuator..
Other useful diagram (Thanks to AndrewC)
JGM
#4
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
3bar with vacuum line disconnected.. (block the vac pipe to the manifold with finger/bolt etc)
I *think* 3bar is standard pressure but not sure.. I have a Link so mapped it for the pressure.
JGM
I *think* 3bar is standard pressure but not sure.. I have a Link so mapped it for the pressure.
JGM
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM