Fitting AFR GAUGE
#2
Scooby Regular
Join Date: Apr 2002
Location: Bournemouth - 5x Ex Impreza owner. 997 GT3 CS.
Posts: 7,333
Likes: 0
Received 0 Likes
on
0 Posts
Some wire to extend to the ECU as the one the gauge comes with would be no doubt be too short. You then just need to locate the right wires to he ECU, strip back, solder on your gauge connections and tape them back up.
What gauge are you getting? If its not the Dawes one, you will probably need a pod to house it in. Scoobymania do a nice corner one.
MB
What gauge are you getting? If its not the Dawes one, you will probably need a pod to house it in. Scoobymania do a nice corner one.
MB
#3
Scooby Regular
Thread Starter
Join Date: Jan 2001
Location: www.ladsoc.co.uk
Posts: 446
Likes: 0
Received 0 Likes
on
0 Posts
Cheers Mark
Its one I got off the indiglo group buy.
I have a 3 gauge pod to fit, have the boost, afr and looking for a third, possibly oil temp if I can find one at the right price.
Its one I got off the indiglo group buy.
I have a 3 gauge pod to fit, have the boost, afr and looking for a third, possibly oil temp if I can find one at the right price.
#4
Scooby Regular
Join Date: Apr 2002
Location: Bournemouth - 5x Ex Impreza owner. 997 GT3 CS.
Posts: 7,333
Likes: 0
Received 0 Likes
on
0 Posts
Autometer do some good / cheaper oil temps. Have a look on JW Racing. I prefer electircal ones for inside the car (just in case!) and would go for an SPA digital, gives both pressure and temp.
MB
MB
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM