Coolant change
Coolant change
07 February 2004, 02:09 PM
#2
Scooby Regular
Join Date: Nov 2003
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
Coolant change..
MAL26....To be honest mal...All i did(becouse mine had some in anyway)Was to drain enough out of the system..And top up with good neat bluecol...This contains the corrosion inhibitants thats required for alloy blocks/parts..I personally only use the Ethelene Glycol stuff..Not the methinol (yellowish orange)...
But if you are wanting the whole water system draining for cleaning out eta....Then be very carefull not to get a airlock..
Just refill the system very slowly..Squeezing the pipes with reasonable agression to displace the air in the pipes..Some people prefer to run the car at the same time...Be very carefull of moving parts / fans eta if you prefer the latter..Good luck..Kev.
But if you are wanting the whole water system draining for cleaning out eta....Then be very carefull not to get a airlock..
Just refill the system very slowly..Squeezing the pipes with reasonable agression to displace the air in the pipes..Some people prefer to run the car at the same time...Be very carefull of moving parts / fans eta if you prefer the latter..Good luck..Kev.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM