Hi folks

I am going to remove the rear light clusters tomorrow and can I just check something?

Five nuts to remove and then is it just the silicone sealant holding in the unit? I don't want to break anything so are there any tips? Cut seal with a knife or just tap then out?

I don't want B & Q bathroom sealant either any ideas on type? Preferable that black semi setting stuff the pros use?

Thanks


Mark

 

Yep, five nuts in total and then just the sealant after that.

Recommend heating up the gorilla snot with a hairdryer or something to allow an easier extraction of the lights. Just gently pushed mine out from the back.

 

Lucky I have a hairdryer in the glovebox

Re: the monkey mucus ..........will it be okay to just re-use do you reckon?

Ta

 

Hmmmmmmmmm

 

I re-sealed my lights again using additional sealant. Chances are if you rely just on the snot again, the seal won't be as good and you'll get a water leak.

 

Thanks GOldeneye

One last question...where do you get the black sealant in question??

Ta

Mark

Nice new TSL lights installed, as soon as it gets light I'll know if I like 'em.