sir_squeak

hi there everybody,

got myself a 53 reg wrx, been i've and managed to trigger a fault code by mistake, which i've now corrected. but i'd like to clear the warning light without messing about and getting the garage to reset it for me. is there a way to do this? i've read about resetting the ecu using two connectors under the steering column, but they appear to apply to earlier cars.... can anybody shed some light on this for me?

great board you have here, looking forward to posting regularly!

cheers all,
- - rob - -

sir_squeak

tried the good old disconnect the battery for an hour, and hey-presto - sorted....

cheers anyhow

Jolly Green Monster

iTrader: (4)

There is info on this site regarding ecu reset in case you need to do it again etc..

JGM

The_Judge

...although for your MY, I don't think that site will help you too much. Have I read somewhere that the CEL goes out after starting the car 5 times...?

Tony_W

For the bug eyes and newer; the CEL gets removed by ECU re-set after 4 re-starts...or 5 if you want to make sure, but you can hear the relays clicking differently as it resets and the CEL will flash once then disappear...
Remember to warm the car up first to avoid wear on the engine and ancillaries with all your restarts and keep your foot on the clutch.

Tony



[Edited by Tony_W - 12/11/2003 2:50:00 PM]