what power to expect?
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Jun 2003
Location: Scotchland
Posts: 9,200
Likes: 0
Received 0 Likes
on
0 Posts
i got 265bhp and 252 torque on me last dyno run, but i was wondering what to expect when i have fitted a td05 front entry and a mapped by BRD link ecu? i have a my99 with full revolution decat, blitz induction kit. had an up-pipe at time of dyno run and also a dawes, but both are now off the car. i will also have ported my headers by the time the link is fitted.
cheers in advance
cheers in advance
#5
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Jun 2003
Location: Scotchland
Posts: 9,200
Likes: 0
Received 0 Likes
on
0 Posts
rotflmao
i was at least expecting to break the 300 barrier anyway, but wasn't sure
should i get a boost controller, other than me dawes valve, before i get the link?
what has other peeps got from the same mods?
i was at least expecting to break the 300 barrier anyway, but wasn't sure
should i get a boost controller, other than me dawes valve, before i get the link?
what has other peeps got from the same mods?
#6
Scooby Regular
Join Date: Apr 2003
Location: East Lothian
Posts: 975
Likes: 0
Received 0 Likes
on
0 Posts
Link would be mapped to whatever you have fited at time.
I.E. 2 port/3 port/Pre-set Dawes.
If you change. Adjust Dawes or fit adjustable electronic.
It's then. Up to you.
Map. Again!
I.E. 2 port/3 port/Pre-set Dawes.
If you change. Adjust Dawes or fit adjustable electronic.
It's then. Up to you.
Map. Again!
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM