wheel studs
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Mar 2001
Location: Here and there
Posts: 8,353
Likes: 0
Received 0 Likes
on
0 Posts
Whilst i was undoing my wheel nuts i found one of them to be really tight,so me being a cheif muppet thought that if i gave it a sharp turn with the wheel brace i might break the seal and it would undo as the others did.So i gave it a sharp turn and it snapped (off).Is it safe to drive with just 4 bolts holding the wheel on or will i need a new hub.I can get a wheel nut on just about to biting point on the snapped stud will this suffice (need a new wheel nut first)
Cheers
Daren
Cheers
Daren
#2
Darren,
I done exactly the same, I drove round for 4 days with only 4 studs & nuts holding on and it was fine. No problem with that..
You will not need a new wheel hub, just a new stud, I had one done at my local garage and the stud was only £5 I think.
Don't panic mate, but do get it sorted just for peace of mind.
Neil
I done exactly the same, I drove round for 4 days with only 4 studs & nuts holding on and it was fine. No problem with that..
You will not need a new wheel hub, just a new stud, I had one done at my local garage and the stud was only £5 I think.
Don't panic mate, but do get it sorted just for peace of mind.
Neil
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 07:28 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM