Have a 94 UK, pretty much totally standard apart from a H&S back box. Will fitting one of these do any damage to sensors/engine etc??? Or is it best sticking to standard?

Many thanks

 

Eveing mate - I ran an ITG panel Filter on MY93 WRx with a slightly adapted airbox and induction pipe. Had no problems whatsoever and the car felt so much better than when i had been running with PiperX induction cone. I had however also removed the resonator in the wing and drilled some very small holes into the bottom of the airbox. I ended up also changing the standard plenum chamber for the MRT job. Nice bit of induction sound (but not too loud) and you could slightly hear the recirc d/valve and the car pulled very well. The only donw side I found to fitting the ITG was an amount of goop (oil) had drained from the filter and was in the bottom of the airbox. I cleaned this out and had no other problems.



Hope this helps.