Knocklink sensitivity
#1
Scooby Regular
Thread Starter
Join Date: May 2003
Location: Warsaw Poland
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
I fitted my knocklink some time ago and set sensitivity to maximum. Now it flashes sometimes although nobody can hear any pinging. Can it be too sensitive? How can I calibrate it?
Marcin
I fitted my knocklink some time ago and set sensitivity to maximum. Now it flashes sometimes although nobody can hear any pinging. Can it be too sensitive? How can I calibrate it?
Marcin
#2
Scooby Regular
Join Date: Sep 2001
Location: Kingston ( Surrey, not Jamaica )
Posts: 4,670
Likes: 0
Received 0 Likes
on
0 Posts
it should just light the second green at 75% maximum load ( so the instructions say ), and all of them if you hit the block *next* to the sensor with a spanner.
Steve
Steve
#3
Scooby Regular
Fitted mine at the weekend (on second bottom end so can't be too carefull !!) Engine run in, I get one green light (faintly) upto 4000rpm, then it gets bright if i go over 4000rpm, can only get second green light (along with all others) to illuminate if I belt the block with something metallic.
Thread
Thread Starter
Forum
Replies
Last Post
blockhead
Subaru Parts
19
07 November 2015 11:50 PM