how hard is it to fit ...
#2
Not at all really, get the rear seat out, remove the oval blanking plate, brush off the worst of the crud....remove the 8 nuts (or summint like that), and up comes the armature.
You will have to turn and fiddle slightly to get it up, and back in again.
/J
You will have to turn and fiddle slightly to get it up, and back in again.
/J
#4
Make sure you get one with the same electrical screw posts as original. mine came with a block connector that took a bit of soldering to sort out. not difficult just more messing than necessary.
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM