Hi All,

I have just gotten myself a Techegde WB V2 and,
I´m just wondering wich signal to use as a rpm signal on a my99 euro GT....

thanks,
Skassa


[Edited by Denmark - 8/28/2003 9:31:45 PM]

 

The ECU->Tacho signal (B135 pin 14?) would seem to be a good bet but be aware that the waveform is 0-12V so you will have to set the J4 jumper to COIL.

I haven't tried it with mine yet as I'm not installing it until I have the calibration software.

Also there has been quite a bit of traffic on the Yahoo mailgroup about deciphering the RPM data in the RS232 datastream.

Andrew...

 

Thanks,
I haven´t installed mine yet,becourse that They forgot to send the boschsensor with the kit..

I think i read that it´s already on the 0-12v jumper??

It just needs a new software ,and then it can log EGT....that will be great.

Thanks,
Skassa

 

Skassa,

You're right if you leave J4 unjumpered then it will default to COIL.

I bought the cheapo 057 sensor from 1st VW before they ran out!

I was really impressed with the TE kit, and it arrived 12 days after ordering!

Andrew...