Toe-in conversion, mm to degrees
#1
Hi all,
Can somebody tell me how to convert the 1 mm toe-in recommendation from Prodrive into degrees which is the only thing the local alignment machine understands, tnks!
Can somebody tell me how to convert the 1 mm toe-in recommendation from Prodrive into degrees which is the only thing the local alignment machine understands, tnks!
#2
Hello Frank,
I too was going to use the Prodrive settings for my geometery set up some time ago now, and worked out the 1mm toe-in on a 16 inch wheel was 16.7 minutes.
Gary
Edited to say this is on each wheel not combined.
[Edited by LB4 - 8/21/2003 6:50:35 PM]
I too was going to use the Prodrive settings for my geometery set up some time ago now, and worked out the 1mm toe-in on a 16 inch wheel was 16.7 minutes.
Gary
Edited to say this is on each wheel not combined.
[Edited by LB4 - 8/21/2003 6:50:35 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM