Fitting Gauges (Oil Temp & Pressure)
#1
Will be fitting the 2 gauges below along with the Boost Gauge I already have, to a center pod on an MY00 Dash.
Any advice on the sender units required for the mechanical Oil Presure and Electrical Oil Temp would be appreciated.
I understand that clearance around the Alternator can be a problem if the incorrect sender is used.
P.S How do the gauges fit into the pod as they come with brackets and 2 long threaded studs, but I cannot visualise how they will secure.
[Edited by Scott.T - 3/14/2003 8:54:42 PM]
Any advice on the sender units required for the mechanical Oil Presure and Electrical Oil Temp would be appreciated.
I understand that clearance around the Alternator can be a problem if the incorrect sender is used.
P.S How do the gauges fit into the pod as they come with brackets and 2 long threaded studs, but I cannot visualise how they will secure.
[Edited by Scott.T - 3/14/2003 8:54:42 PM]
#6
Pete,
Will be interested in one of your pods.... are you able to get the senders too ?
How do the gauges secure in the Pod ?
Glad to hear the cars nearly ready Bryan... that engine bay up to concourse standard yet ?
[Edited by Scott.T - 3/16/2003 7:31:37 PM]
Will be interested in one of your pods.... are you able to get the senders too ?
How do the gauges secure in the Pod ?
Glad to hear the cars nearly ready Bryan... that engine bay up to concourse standard yet ?
[Edited by Scott.T - 3/16/2003 7:31:37 PM]
#7
Scooby Regular
Join Date: Mar 2001
Location: Focus RS slightly modified!!
Posts: 1,716
Likes: 0
Received 0 Likes
on
0 Posts
Hi Scott,
Call me a sad ******* but I went and cleaned the car 2 weeks ago and whilst there gave the engine bay a good going over with some gunk and a paint brush, engine should have gone in Friday I will know tomorrow. Also the coilovers and all four new strut braces should be on tomorrow
I may see you next week, need to put some miles on the engine before the 5th April.
Bryan
Call me a sad ******* but I went and cleaned the car 2 weeks ago and whilst there gave the engine bay a good going over with some gunk and a paint brush, engine should have gone in Friday I will know tomorrow. Also the coilovers and all four new strut braces should be on tomorrow
I may see you next week, need to put some miles on the engine before the 5th April.
Bryan
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM