defi-link control unit 2
#1
Scooby Regular
Thread Starter
Join Date: May 2001
Location: 354bhp/325lb/ft :):)
Posts: 309
Likes: 0
Received 0 Likes
on
0 Posts
can some one please tell how to set up my defi-link control unit
fitted it today with a boost gauge
needle sits at 0 when switched off is this right
thanks
Neil
#2
Scooby Regular
iTrader: (1)
Join Date: Oct 2001
Location: South East
Posts: 1,300
Likes: 0
Received 0 Likes
on
0 Posts
No . dont think it is! I think u'll find you still have pwr to it somewhere!
when I turn my key to ACCESSORY, the DEFI's do their [very cool ] startup routine. then sit @ Zero.
when I stop the engine, it goes back to Zero, until I take the key out all toghether! at which point it drops down south onto it's rest.
try tracing the wiring & seeing what it's wired too.
Steve
when I turn my key to ACCESSORY, the DEFI's do their [very cool ] startup routine. then sit @ Zero.
when I stop the engine, it goes back to Zero, until I take the key out all toghether! at which point it drops down south onto it's rest.
try tracing the wiring & seeing what it's wired too.
Steve
#3
Hi Neil,
The reason why your boost gauge needle sits at 0 when switched off
Is that the control unit requires a permanent power feed even when the ignition is off.
You’ll probably also have noticed that you will be loosing all the warning settings and replay data as well.
Make sure the RED wire has a permanent power feed to it.
The ORANGE wire should be connected to the ignition switch.
Hope this helps?
Cheers,
Rob
P1 Web Owners Club
www.P1woc.co.uk
The reason why your boost gauge needle sits at 0 when switched off
Is that the control unit requires a permanent power feed even when the ignition is off.
You’ll probably also have noticed that you will be loosing all the warning settings and replay data as well.
Make sure the RED wire has a permanent power feed to it.
The ORANGE wire should be connected to the ignition switch.
Hope this helps?
Cheers,
Rob
P1 Web Owners Club
www.P1woc.co.uk
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM