Autometer Air/fuel ratio guage wiring instuctions!!?
#4
Scooby Regular
Join Date: Mar 2000
Location: Tayside
Posts: 2,323
Likes: 0
Received 0 Likes
on
0 Posts
white one with the screening around it
Can`t remember the pin number though
It`s in the first block (one closest 3 u) when u take the
footrest off the top of it (block nearest the passanger seat)
I did a qwik diagram of this b 4 but buggered if i can remember where i put it
Pete
Can`t remember the pin number though
It`s in the first block (one closest 3 u) when u take the
footrest off the top of it (block nearest the passanger seat)
I did a qwik diagram of this b 4 but buggered if i can remember where i put it
Pete
#6
Scooby Regular
Join Date: Mar 2000
Location: Tayside
Posts: 2,323
Likes: 0
Received 0 Likes
on
0 Posts
RF screening (like aluminium tape)
Bear in mind the signals travelling between the lambda sensor & ECU are very small and any electrical interference would give faulse values back to the ECU. This would then in turn cause the system to lean out or enrichen the air / fuel mix depending on how the signal is altered by surrounding electrical interference.
Hope this makes it a bit clearer
Pete
Bear in mind the signals travelling between the lambda sensor & ECU are very small and any electrical interference would give faulse values back to the ECU. This would then in turn cause the system to lean out or enrichen the air / fuel mix depending on how the signal is altered by surrounding electrical interference.
Hope this makes it a bit clearer
Pete
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM