Can anyone give me distructions on how to change a P/S Pump/motor on a classic WRX please

Thank you in advance

 

Hi,

First thing is to suck the fluid out of the res tank, i used an old antifreeze tester tube, then undo the metal pipe going to the pump and loosen the rubber pipe next to it.

then undo the three bolts at the front on the pump you need to put a socket through the pulley wheel (abit fidderly).
next go to the back of the pump and theres one bolt attached to the manifold , then pull off the wire .

to get the pump out and to free it from the two pipes i had to move the header tank and theres a bracket holding the pipes steady loosen the bracket and it should make it easier to move the pipes .

from memory i think thats it
hope that helps abit
nick.

 

Cheers mate I shall wreck the engine on Monday night

 

Dont forget to take the belt off..

Sorry couldnt resist

Rob

 

I knew I was forgetting something!!