Hi Guys,

I have an odd ask of you all, I'm from sydney australia and recently imported a v3 RA front cut for installation into my series II legacy/liberty.. my mechanic wired it all up to australian standards and the thing never ran right, after 10-15 minutes the car would hit 4000rpm and cut.. and just bounce at 4000rpm... if I disconnected the ecu and left it (ecu reset) the car would be fine again, my mechanic said the ecu was the problem, he tried an AUST spec ecu, and the car runs fine.. however not as well as it should.. I have the australian spec ecu pinouts, however I need to get my hands on the jap spec pinouts, which I am assuming would be the same as what you guys over there have, so basically I need the pinouts for say 93-96/7 Impreza... anywhere in that time line should be perfect.. if somebody could help me out it would be greatly appreciated.. I can be contacted either on email karupt@karupt.com or icq: 910284 or by replying on here..

Thanks in advance..

Andrew