ECU error code 24 after fitting lambdalink???????
#1
After a bit of fiddling about im pretty sure my lambdalink is working ok. Its wired at the ECU at senor signal and ground (not shield). However i now get the check engine light flicking on now and again. After checking the fault code it came back 24 (two long lights followed by 4 short lights), i beleive this is the idle air control solenoid?????? Is this just a coincidence cause i can't see how they relate?
Having said that i drove to work this morning (25 miles) and no check engine light, im confused
Tony.
Having said that i drove to work this morning (25 miles) and no check engine light, im confused
Tony.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM