Head stud RCM1635
#1
Scooby Regular
Thread Starter
Head stud RCM1635
Got a 2.5 wrx to replace the head gaskets and have some RCM1635 head studs.
Anyone got an idiots guide in fitting including torque specs?
Anyone got an idiots guide in fitting including torque specs?
#3
Scooby Regular
Thread Starter
Yeah, got the torque sheet online.
Am I correct in guessing the flat end into the block hand tight, then fit the nuts to the torque settings?
Am I correct in guessing the flat end into the block hand tight, then fit the nuts to the torque settings?
#4
Scooby Regular
no the end with the machined "nipple" is the block side, flat end is for the nut up top........
wind them till they just touch the base of the block and then back off 1/2 turn
wind them till they just touch the base of the block and then back off 1/2 turn
The following users liked this post:
Thread
Thread Starter
Forum
Replies
Last Post