Off centre & droopy Prodrive exhaust for Blobeye WRX
#1
Scooby Newbie
Thread Starter
Off centre & droopy Prodrive exhaust for Blobeye WRX
Hello all,
As you can see from the photo, the Prodrive exhaust is not centred and also dips down and off to the right. It has always been like this since I bought in January. I have noticed it on a few other cars whilst browsing the net, so I wondered if it was a common problem and fingers crossed a common fix!
Any help would be much appreciated.
Dan @ Surrey Subaru said the centre section is out of alignment so when it is bolted back up it throws it out. Is this a manufacturing fault?
Last edited by Rom4; 11 August 2021 at 04:57 PM.
#2
Scooby Regular
Might need to replace the rubber hangers mate.
#4
Scooby Regular
Guys were fitting an exhaust, wasn't a scooby, it just would line up properly. Rubber hangers looked fine but it was only after they bought new ones and compared them that the difference was noticeable.
That might not be your issue and someone with your exhaust fitted might be able to give a better answer.
That might not be your issue and someone with your exhaust fitted might be able to give a better answer.
Thread
Thread Starter
Forum
Replies
Last Post