Power steering????
#1
Scooby Newbie
Thread Starter
Join Date: Aug 2011
Location: middx
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Power steering????
hi guys;changed my o ring on low pressure side;think I expelled the air by going lock to lock loadsa times;pump/rack still squealing on occasion.i have checked high pressure hoses and can’t see any leaks;when cold if I start car steering heavy and squeals a bit;fluid level not dropping and no sign of air bubbles;when driving all seems ok ;only noticeable if I have to turn full lock to say get out of parking space;;seems easier if I rev the engine;;any advise please;cheers Mick
#4
Scooby Newbie
Thread Starter
Join Date: Aug 2011
Location: middx
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Car is Hawkeye 2006;97000 but has full main dealer history so fluid would have been done as per service schedule;colour is reddish I thinkwhen I changed o ring on low pressure side of pump;however when I expelled air ;bubbles from reseviour looked brownish
#6
Scooby Regular
Not part of service schedule so probably best to change it.
#7
Scooby Regular
iTrader: (3)
If there are bubbles then you may still have a leak. The spring clips they use in the hoses loose tension over time and allow a small amount if air in, so replace these with jubilee clips.
If no bubbles and still noisy then I'd look at the belt tension.
Hopefully it's not the pump or rack.
If no bubbles and still noisy then I'd look at the belt tension.
Hopefully it's not the pump or rack.
Trending Topics
#8
Scooby Newbie
Thread Starter
Join Date: Aug 2011
Location: middx
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
No bubbles in fluid;drained off fluid;was nearer black than red;jacked up front (wheels off ground)did full lock to full lock for 2/3 mins;no squealing ;checked fluid -no bubbles ;level good;dropped car;seemed good on drive round ;but still lumpy when turning from tight space on low revs;gunna check belt tension tonight???
#9
Scooby Newbie
Thread Starter
Join Date: Aug 2011
Location: middx
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Sorted;;well pleased;tightened tension on belt and that’s it;did look at it yesterday and seemed ok but then watched u tube video and tightened as suggested in video;belt must have been slipping under load ????
Thread
Thread Starter
Forum
Replies
Last Post
The Rig
General Technical
3
28 February 2019 06:54 AM