Hi just need a bit of guidance I've got a UK classic had her for years now , bottom end started knocking as well has head gasket on it way out , it's only done 116k original engine from new 97 , anyway got chance of a gc8 jdm Sti engine import low mileage , my question is will it fit ? Will I have to swap the ecu ect , and help much appreciated

 

Any engine can be made to fit any car,depends on how much work you want to do?
What version is the sti engine from? Will you be using the long engine or using your heads?
If using the long engine you will want the ecu from that version car and will at least swap a few pins over as the UK loom is slightly different.

 

Hi it's advertised as v5 6 jdm classic , didn't want another UK engine , as I'm aware the above engine is much better and and has forged internals ,

 

It's going to take a fair bit more work to sort if you intend using the v5/6 heads.

 

For what reasons m8?

 

I've got chance of the full engine , thought with it been from a classic should go straight in ? But I'm no mechanic that s why on I'm here asking for advice ,

 

Different inlet manifold, icv, throttle body, possibly injectors, loom, could keep going.

 

Right nothing just straight forward 🙈 my other option was a ej207 bottom end and use my manifold ect , been told that'll work probably just have to get oil cooler ?

 

Heading the right direction just make sure you get the correct head gaskets.

 

Is the ej207 bottom end a better option ? Was told if I purchased the bottom end I could use my top end pats off my old engine is this correct guys ?

 

There are a few options/variations of the ej207 but will all work with your heads etc,just the extra breather to delete.
Also believe the v5/6 jdm is ej207 and UK ej205 (not 100% sure tho)

 

Much appreciated guys for your help , I've got a couple of options , so I'll hav a think about it cheers