NotCarlsson

I had too remove some old water pipes on my GC8 since they had holes in they and squirted out water.

Last night I tried to bleed the system, how ever when idle the water temp dosen't seem to want to go over 74C, and when I push down the throttle the water imedelty goes down too 60ish C

Jonny Cut Corners

Have you got a high flow thermostat fitted?

NotCarlsson

I have not, I was just confused as it didn't do that before I changed some water pipes.
How ever now it's running at 90 ish and when ever I step on the gas it'll immediately go down. Too 80C ish. But it seems too be working.

alcazar

iTrader: (2)

1. There is no known way to bleed the colling system. Burping it sometimes works but is not 100% especially on a GC8.

2. Drain and use my method to refill. https://www.scoobynet.com/general-te...-question.html