PCV setup with Perrin inlet hose and FMIC?
30 June 2017, 07:57 AM
#1
PCV setup with Perrin inlet hose and FMIC?
Need to figure out how I am setting up the PCV stuff once I fit the front mount and the intake hose. It's a Blob STI so AVCS heads.I have a CDF 3 port catch can that I could also fit at the same time.
A couple of people I asked said something about blanking the outlets on the silicone intlet hose and taking connections from the heads somewhere? The Perrin hose though has a seat for the PCV diagnosis connector so with that, should I connect that then cut that hose in half and bung it and tee the other half of it into the catch can pipework or something else?
A couple of people I asked said something about blanking the outlets on the silicone intlet hose and taking connections from the heads somewhere? The Perrin hose though has a seat for the PCV diagnosis connector so with that, should I connect that then cut that hose in half and bung it and tee the other half of it into the catch can pipework or something else?
