What's needed to fit equal length headers?
19 June 2016, 10:45 PM
#1
Scooby Newbie
Thread Starter
Join Date: Mar 2016
Location: Worthing
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
What's needed to fit equal length headers?
Hi there Im planning on fitting some equal length headers and have been told I need to fit a sump and oil pick up from a 2.5. Can anyone confirm exactly what I need and also subaru part numbers would be awesome but if not that's fine. (before it turns into a boring argument about unequals are better I just wana clarify Im fitting these no matter what!)
Thanks
Thanks
19 June 2016, 11:59 PM
#2
Hi there Im planning on fitting some equal length headers and have been told I need to fit a sump and oil pick up from a 2.5. Can anyone confirm exactly what I need and also subaru part numbers would be awesome but if not that's fine. (before it turns into a boring argument about unequals are better I just wana clarify Im fitting these no matter what!)
Thanks
Thanks
20 June 2016, 08:34 AM
#3
Hi there Im planning on fitting some equal length headers and have been told I need to fit a sump and oil pick up from a 2.5. Can anyone confirm exactly what I need and also subaru part numbers would be awesome but if not that's fine. (before it turns into a boring argument about unequals are better I just wana clarify Im fitting these no matter what!)
Thanks
Thanks
From the recent extensive thread on this subject it depends on the manifold that you buy. The Killer Bs that seem to be the best choice require a lot of other modifications whereas the RCMs etc are a direct bolt-on replacement.
Thread
Thread Starter
Forum
Replies
Last Post
chris_subie
General Technical
0
10 April 2016 06:46 AM
WellsR
General Technical
0
05 April 2016 10:03 PM