WRX 2.5 Big end wear - Easy fix ?
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Nov 2011
Location: Rotherham
Posts: 424
Likes: 0
Received 0 Likes
on
0 Posts
WRX 2.5 Big end wear - Easy fix ?
My 2.5 engine has a bit of big end noise. Is this an easy fix ? Can you re shell the big ends with engine in car ?
Any Garages or engine builders in South Yorkshire want to re shell my big ends for me ?
2008 WRX 2.5 Hatch.
Any Garages or engine builders in South Yorkshire want to re shell my big ends for me ?
2008 WRX 2.5 Hatch.
#2
Scooby Regular
iTrader: (1)
Its a bit more than just replacing the shells its going to need a full strip down to remove the crank, the block has to be split to remove the crank, the bottom end will have failed because of wear or det so a full rebuild will be required, best of forging the engine while its apart as the 2.5 is of a weak design.
#4
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Nov 2011
Location: Rotherham
Posts: 424
Likes: 0
Received 0 Likes
on
0 Posts
Its a bit more than just replacing the shells its going to need a full strip down to remove the crank, the block has to be split to remove the crank, the bottom end will have failed because of wear or det so a full rebuild will be required, best of forging the engine while its apart as the 2.5 is of a weak design.
drives well though still , plenty of power and still a pleasure to drive.
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
General Technical
41
19 April 2016 06:06 PM