challengerGT97

Hi everyone,

I have a big problem with my subaru GT97 wagon. After replacing head gaskets, engine not start. It is cranking but not start only first time for a while (1 sec on idle). But after this its only cranking. I already checked and replace almost everything:
-new vacuum hoses
-new ignition coil
-new spark plugs
-new ignition cables
-all new filters
-new immobiliser key
-new crankshaft and camshaft sensors
-new mass air flow sensor
Also I checked everything what i can
-cylinder compression
-fuel pressure
-timing belt

I have Ej205 with NO modifications. It is possible that vacuum leak cause that problems? Or maybe its injectors?
Please help, maybe You have some advices what else i can do to start my subaru.

Chan HT

Try removing all spark plugs and blow with dry air to dry them out. Could be covered with fuel from all your star attempts.
Hope this helps.

challengerGT97

I already did it many times and it didn't but hel for advise. I saw something courious. When i remove spark plugs i saw that on the left head spark plugs are smoked so there is a ignition, but on the right head spark plugs are like newone but wet from gasoline. What can cause that? I checked spark and it's ok on all 4 cylinders. So theoretical on the right head ignition should be too.