VF34 oil feed question
#1
Scooby Regular
Thread Starter
Join Date: Sep 2012
Location: Dorset
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
VF34 oil feed question
I am replacing the TD05h on my engine with a VF34 IHI turbo, my question is with regard to the oil feed for the IHI, i am sure i need to run an oil restrictor, does anyone know the size ie 1mm hole?
My current setup is a male male fitting into the turbo followed by a JIC fitting with 90 deg bend and then braided hose.
Ideally i would like to just replace the male male fitting with one with an oil restriction and not full bore (i am not running banjo fitting). I took the male male fitting out earlier and the size appeared to be m10x1.5 (turbo side) then M11x1.25 JIC fitting side.
Can anyone point me to the fitting i need please
Thanks
My current setup is a male male fitting into the turbo followed by a JIC fitting with 90 deg bend and then braided hose.
Ideally i would like to just replace the male male fitting with one with an oil restriction and not full bore (i am not running banjo fitting). I took the male male fitting out earlier and the size appeared to be m10x1.5 (turbo side) then M11x1.25 JIC fitting side.
Can anyone point me to the fitting i need please
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM