2.5 engine conversion
Thread Starter
Scooby Newbie
Joined: Oct 2014
Posts: 12
Likes: 0
From: scotland
2.5 engine conversion
Evening guys am putting a full 2.5 engine in my blob eye and have noticed the 2.0 has 3 cam sensors and the 2.5 only has 2 which have 3 wires where as the 2.0 sensors only have 2 wires. Anybody done this conversion if so what was required to get the car running
Cheers
Cheers
Your blob ECU will not work with this setup. You will either need to use the ECU from the 2.5, with a major wiring rework, or go for something like a Syvecs which will be much more flexible when it comes to the different sensor arrangement (but will still need some wiring changes).
Or, fit the heads from the 2.0l and thereby retain the original 3 off 2-pin sensors. The heads will need machining to suit.
Or, fit the heads from the 2.0l and thereby retain the original 3 off 2-pin sensors. The heads will need machining to suit.
Thread Starter
Scooby Newbie
Joined: Oct 2014
Posts: 12
Likes: 0
From: scotland
Your blob ECU will not work with this setup. You will either need to use the ECU from the 2.5, with a major wiring rework, or go for something like a Syvecs which will be much more flexible when it comes to the different sensor arrangement (but will still need some wiring changes).
Or, fit the heads from the 2.0l and thereby retain the original 3 off 2-pin sensors. The heads will need machining to suit.
Or, fit the heads from the 2.0l and thereby retain the original 3 off 2-pin sensors. The heads will need machining to suit.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM